Acronis Snap Deploy 5 - User Guide - Manual (Page 117)

117 Copyright © Acronis International GmbH, 2002-2014
Note: Acronis Snap Deploy 5 Standalone Utility can be placed on a physical media only. This component is
not designed to boot from a PXE server or from a WinPE-based bootable media.
The Acronis stand-alone components to be placed on the bootable media
3. Configure the master system.
4. Boot the master system into Acronis Snap Deploy 5 Master Image Creator. Create an image of
the master system and save it to a network folder, detachable media, or removable media. You
should not save the image to an internal hard disk of the target machine, because it cannot be
accessed during the stand-alone deployment.
5. Boot the target machine into Acronis Snap Deploy 5 Standalone Utility.
6. If you saved the master image to a media, attach or insert the media.
Acronis Snap Deploy 5 Standalone Utility can deploy an image located:

In a network folder.

On a USB or FireWire (IEEE-1394) storage device (such as a flash drive) attached to the target
machine.

On DVD+R/RW, DVD-R/RW, CD-R/RW, or recordable Blu-ray Discs (BD-R, BD-RE) loaded in
the target machine’s media drive.
The image created on removable media has to fit into one media disk. To deploy an image spread
over several CDs, DVDs or other media, copy all parts of the image to the same folder on an
external drive or to a network folder.
7. Configure the deployment operation as described in “Creating a deployment template” (p. 85).
Note that the template cannot be saved because the stand-alone utility does not access Acronis
Snap Deploy 5 OS Deploy Server.
8. Review the deployment settings, and then start the stand-alone deployment.