Dell PowerEdge T610 User Manual

Page 100

Advertising
background image

100

Installing System Components

4 Remove the cooling shroud. See "Removing the Cooling Shroud."
5 Disconnect the internal USB module cable from the connector on the

system board, and unroute the cable from the cable guides in the chassis.
See Figure 3-12.

6 Pull up on the module release tab, and slide the internal USB module to

remove it from the slots in the chassis. See Figure 3-12.

7 Install the cooling shroud. See "Installing the Cooling Shroud."
8 Install the expansion card stabilizer. See "Installing the Expansion Card

Stabilizer."

9 Close the system. See "Closing the System."

10 Place the system upright and on its feet on a flat, stable surface.
11 Reattach any peripherals, then connect the system to the electrical outlet.
12 Turn on the system and attached peripherals.

book.book Page 100 Tuesday, September 15, 2009 10:08 AM

Advertising