Dell PowerEdge T610 - Manual (Page 143)

Installing System Components
143
c Disconnect the power cables from any internal optical or tape drives, if
present. See "Removing an Optical or Tape Drive."
d Pull the cables up and away from the notch in the backplane board.
CAUTION:
The backplane signal cable can only be disconnected after the
backplane has been removed. Be careful not to pull excessively on the cable
when removing the backplane board. Doing so can damage the cable.
8 Remove the SAS backplane:
a Pull the blue backplane release pin. See Figure 3-25.
b While pulling the release pin, slide the backplane upwards.
c Pull the backplane board away from the front of the system until the
securing slots are free from the tabs in the chassis, and lift the board
from the chassis.
9 Disconnect the backplane signal cable from the backplane. See
Figure 3-25.
book.book Page 143 Tuesday, September 15, 2009 10:08 AM