Dell PowerEdge T610 - Manual (Page 172)

172
Troubleshooting Your System
6 Ensure that each expansion card is firmly seated in its connector. See
"Installing an Expansion Card."
7 Install the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer."
8 Close the system. See "Closing the System."
9 Place the system upright and on its feet on a flat and stable surface,
reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
10 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
11 Open the system. See "Opening the System."
12 Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer."
13 Remove all expansion cards installed in the system. See "Installing an
Expansion Card."
14 Install the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer."
15 Close the system. See "Closing the System."
16 Place the system upright and on its feet on a flat and stable surface,
reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
17 Run the appropriate online diagnostic test.
If the tests fail, see "Getting Help."
18 For each expansion card you removed in step 13, perform the following
steps:
a Turn off the system and attached peripherals, and disconnect the
system from the electrical outlet.
b Remove the expansion card stabilizer. See "Removing the Expansion
Card Stabilizer."
c Open the system. See "Opening the System."
d Reinstall one of the expansion cards.
book.book Page 172 Tuesday, September 15, 2009 10:08 AM