Dell PowerEdge T610 - Manual (Page 118)

118
Installing System Components
Figure 3-18. Removing and Installing a RAID Battery
Installing a RAID Battery
1 Insert the RAID battery into the battery carrier. See Figure 3-18.
2 Insert the battery carrier with the RAID battery into the battery carrier
slots until the carrier release latch locks into place. See Figure 3-18.
3 Connect the battery cable to the connector on the integrated storage card
(see Figure 3-17) and replace the integrated storage controller card. See
"Installing an Integrated Storage Controller Card."
Expansion Cards
The system board can accommodate up to five PCIe Generation 2 expansion
cards:
• Two full-height, full-length (12.2-inch) PCIe x8 link (slots 2 and 3)
1 battery cable connector 2 RAID battery
3 battery carrier tabs (2) 4 battery carrier slots (2)
5 battery carrier 6 battery carrier release tab
5
3
2
4
1
6
book.book Page 118 Tuesday, September 15, 2009 10:08 AM