Dell PowerEdge T610 - Manual (Page 30)

30
About Your System
E1626 Power Supply
Mismatch. PSU1
= ### W, PSU2
= ### W.
The power supplies in the
system are not the same
wattage. Ensure that power
supplies with matching
wattage are installed. See
the Technical
Specifications outlined in
your system’s Getting
Started Guide.
E1629 Power required
> PSU wattage.
Check PSU and
config.
The system configuration
requires more power than
the power supplies can
provide, even with
throttling. Turn off power to the
system, reduce the
hardware configuration or
install higher-wattage
power supplies, and then
restart the system.
E1710 I/O channel
check error.
Review & clear
SEL.
The system BIOS has
reported an I/O channel
check. Check the SEL for more
information and then
clear the SEL. Remove
AC power to the system
for 10 seconds and restart
the system.
If the problem persists,
see "Getting Help."
E1711 PCI parity
error on Bus
## Device ##
Function ##
The system BIOS has
reported a PCI parity error
on a component that
resides in PCI
configuration space at bus
##, device ##, function
##. Remove and reseat the
PCIe expansion cards. If
the problem persists, see
"Troubleshooting
Expansion Cards."
PCI parity
error on Slot
# . Review &
clear SEL.
The system BIOS has
reported a PCI parity error
on a component that
resides in the specified
slot. Remove and reseat the
PCIe expansion cards. If
the problem persists, see
"Troubleshooting
Expansion Cards."
Table 1-1. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 30 Tuesday, September 15, 2009 10:08 AM