Dell PowerEdge T610 - Manual (Page 61)

Using the System Setup Program and UEFI Boot Manager
61
Memory Settings Screen
F1/F2 Prompt on Error
(Enabled default) Enables the system to halt on errors during POST, which
allows the user to observe events that may scroll by
unnoticed during normal POST. The user can select F1
to continue or F2 to enter the System Setup program.
CAUTION:
When setting this option to disabled, the
system will not halt if an error occurs during POST.
Any critical errors will be displayed and logged in
the system event log.
Option Description
System Memory Size Displays the amount of system memory.
System Memory Type Displays the type of system memory.
System Memory Speed Displays the system memory speed.
Video Memory Displays the amount of video memory.
System Memory Testing
(Enabled default) Specifies whether system memory tests are run at system
boot. Options are Enabled and Disabled.
Memory Operating Mode This field displays the type of memory operation if a
valid memory configuration is installed. When set to
Optimizer Mode, the memory controllers run
independently of each other for improved memory
performance. When set to Mirror Mode, memory
mirroring is enabled. When set to Advanced ECC
Mode, two controllers are joined in 128-bit mode
running multi-bit advanced ECC. For information about
the memory modes, see "System Memory."
Node Interleaving
(Disabled default) If this field is Enabled, memory interleaving is supported
if a symmetric memory configuration is installed. If
Disabled, the system supports Non-Uniform Memory
architecture (NUMA) (asymmetric) memory
configurations.
Option Description
book.book Page 61 Tuesday, September 15, 2009 10:08 AM