Dell PowerEdge T610 - Manual (Page 36)

36
About Your System
E2110 Multibit Error
on DIMM ## .
Reseat DIMM.
The memory module in
slot “##” has had a multi-
bit error (MBE). See "Troubleshooting
System Memory."
E2111 SBE log
disabled on
DIMM ## .
Reseat DIMM.
The system BIOS has
disabled memory single-
bit error (SBE) logging
and will not log anymore
SBEs until the system is
rebooted. "##" represents
the memory module
implicated by the BIOS. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Troubleshooting
System Memory."
E2113 Mem mirror OFF
on DIMM ## &
## . Power
cycle AC
The system BIOS has
disabled memory
mirroring because it has
determined one half of the
mirror has had too many
errors. "## & ##"
represents the memory-
module pair implicated by
the BIOS. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Troubleshooting
System Memory."
I1910 Intrusion
detected.
Check chassis
cover.
System cover has been
removed. Information only.
I1911 LCD Log Full.
Check SEL to
review all
Errors.
LCD overflow message. A
maximum of ten error
messages can display
sequentially on the LCD.
The eleventh message
instructs the user to check
the SEL for details on the
events. Check the SEL for details
on the events.
Remove AC power to the
system for 10 seconds or
clear the SEL.
I1912 SEL full.
Review & clear
log.
The SEL is full of events
and is unable to log any
more. Check the SEL for details
on the events, then clear
the SEL.
Table 1-1. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 36 Tuesday, September 15, 2009 10:08 AM