Compaq PROLIANT ML370 - Manual (Page 18)

2-2 Compaq ProLiant ML370 Maintenance and Service Guide
Electrostatic Discharge Information
A discharge of static electricity can damage static-sensitive devices or microcircuitry. Proper
packaging and grounding techniques are necessary precautions to prevent damage. To prevent
electrostatic damage, observe the following precautions:
■ Transport products in static-safe containers such as conductive tubes, bags, or boxes.
■ Keep electrostatic-sensitive parts in their containers until they arrive at static-free stations.
■ Cover work stations with approved static-dissipating material. Provide a wrist strap
connected to the work surface and properly grounded tools and equipment.
■ Keep work area free of nonconductive materials such as ordinary plastic assembly aids
and foam packing.
■ Make sure you are always properly grounded when touching a static-sensitive component
or assembly.
■ Avoid touching pins, leads, or circuitry.
■ Always place drives PCB assembly-side down.
■ Use conductive field service tools.
Symbols in Equipment
WARNING: Any surface or area of the equipment marked with these symbols
indicates the presence of a hot surface or hot component. If this surface is
contacted, the potential for injury exists. To reduce the risk of injury from a hot
component, allow the surface to cool before touching it.
WARNING: Any surface or area of the equipment marked with these symbols
indicates the presence of electric shock hazards. The enclosed area contains no
operator serviceable parts. To reduce the risk of injury from electric shock
hazards, do not open this enclosure.
WARNING: Any RJ-45 receptacle marked with these symbols indicates a Network
Interface Connection. To reduce the risk of electric shock, fire, or damage to the
equipment, do not plug telephone or telecommunications connectors into this
receptacle.
CLASS 1 LASER PRODUCT
WARNING: This label or equivalent is located on the surface of your CD-ROM
drive. This label indicates that the product is classified as a CLASS 1 LASER
PRODUCT.
Power supplies or systems marked with these symbols indicate the equipment is
supplied by multiple sources of power.
WARNING: To reduce the risk of injury from electric shock, remove all power
cords to completely disconnect power from the system.