Compaq PROLIANT ML370 - Manual (Page 63)

Diagnostics and Troubleshooting 3-9
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of Problem Recommended Action
175 - Configuration/
Slot Mismatch Device
Found None PCI board added, configuration
not updated Run the System Configuration
Utility and correct.
177 - Configuration
Not Complete None Incomplete system configuration Run the System Configuration
Utility and correct.
178 - Processor
Configuration Invalid None Processor type or step does not
match configuration memory Run the System Configuration
Utility and correct.
180 - Log
Reinitialized None N/A N/A
201 - Memory Error None RAM failure Run Diagnostics. Replace failed
assembly as indicated.
203 - Memory
Address Error None RAM failure Run Diagnostics. Replace failed
assembly as indicated.
207 - Invalid Memory
Configuration—
Check DIMM [SIMM]
Installation None Memory module installed
incorrectly Verify placement of memory
modules.
208 - Invalid Memory
Speed—Check
DIMM [SIMM]
Installation 1 long, 1 short The speed of the memory is too
slow, where: xx00 = expansion
board SIMMs are too slow, or
00yy = system board SIMMs are
too slow. xx and yy have
corresponding bit set The speed of the memory
modules must be 60 ns. Verify
the speed of the memory
modules installed and replace.
209 - Memory
Detection Failure.
Check Memory
Installation 1 long, 1 short Unable to size memory Check DIMM installation, and if
error persists, call Compaq
service provider.
211 - Cache Switch
Set Incorrectly None Switch not set properly during
installation or upgrade Verify switch settings.
212 - System
Processor Failed/
Mapped out 1 short Processor in slot x failed Run Diagnostics and replace
failed processor.
214 - DC-DC
Converter Failed None PowerSafe Module (DC-DC
Converter) failed Run Diagnostics. Replace failed
assembly as indicated.
214 - Processor PPM
Failed Module X None Indicated PPM (DC-DC Converter)
failed Replace failed assembly as
indicated.
continued