Dell UPS 1000T - Manual (Page 48)

Configuration 48
You can filter the action according to:
• Event criticalities: Critical, Warning, Normal, Communication Lost
NOTE: With this parameter, you can filter the notification according to the event level. Refer to the event category
list. If you select “Critical” as filter you will not receive the associated “Normal” event informing that the
device status changes from “Critical” to “Normal.”
• Event category: Alarms, Shutdown events, Power events, Measures) as follows:
• Alarms Event Category
• Utility failure
• Communication lost
• Shutdown Imminent
• Battery Low
• Internal Failure
• Overload
• Output On/Off
• Outlets On/Off
• Battery Fault
• On Automatic Bypass
• On Manual Bypass
• Redundancy Lost
• Protection Lost
• Shutdown Events Event Category
• Utility failure
• Battery Low
• Shutdown Imminent
• Local Run Time to Shutdown
• Power Events Event Category
• Output Percent Load
• Output Apparent Power
• Output Active Power
• Output Power Factor
• System Defined Output Overload Alarm
• Measures Event Category
• Output Percent Load
0120_3-Dell ULNM UG.book Page 48 Saturday, November 2, 2013 5:34 PM