Dell UPS 1000T - Manual (Page 81)

Redundancy 81
Redundancy Configuration
To configure redundancy:
1 Login with an administrator user profile.
2 Select two or more nodes.
3 Click Set composite device as shown in Figure 63
Figure 63. Selecting Set Composite Device for Nodes
4 In the dialog box, specify a device name and redundancy mode and level (see Figure 64):
• Device Name: User name of the composite device
• Redundancy Level: The minimal number of redundant UPSs powering your system. The default
value is 0. For example, If you have two UPSs running in N+1 mode, type the numeral 1.
NOTE: If you set this parameter to a higher level, you will receive the “Redundancy Lost” alarm when you do not have
enough redundant UPSs.
0120_3-Dell ULNM UG.book Page 81 Saturday, November 2, 2013 5:34 PM