Dell PowerVault 211S (SCSI) - Manual (Page 26)

1-4 Dell PowerVault 200S, 201S, 210S, and 211S Storage Systems Installation and Service Guide
For hot-plug insertion and removal of SCSI drives, the storage system must be con-
nected to a Dell PERC 2, Dell PERC 2/DC, Dell PERC 2/SC, or Dell PERC 3/DI host
adapter card or other host adapter qualified by Dell.
Dell supports the following network operating systems for use on host computers
connected to the storage system:
‡
Microsoft ® Windows NT ® Server 4.0 or later
‡
Novell ® NetWare ® 4.11 or later
The HP OpenView NNM SE x.x and Dell OpenManage HIP x.x server management
application programs (version 3.2 or later) should be installed on the host computer.
The host computer must have appropriate SCSI device drivers installed. For more
information on these drivers, see the chapter titled "Installing and Configuring SCSI
Drivers" in the host computer's User's Guide.
,QGLFDWRUV
(QFORVXUH ,QGLFDWRUV
The following enclosure status indicator lights are located on the front panel of the
enclosure (see Figure 1-1):
‡
The green power indicator lights when the storage system is turned on.
‡
The green dual-bus indicator (middle) lights when the PowerVault 2xxS is
operating in dual-bus split backplane mode.
‡
The amber system fault indicator lights if one of the storage system's
internal self-tests fails during system start-up or whenever a fault is detected.
NOTE: You can use Dell OpenManage HIP to enable an audible fault indicator. See the
HP OpenView NNM SE x.x and Dell OpenManage HIP x.x documentation.