Installing the stand-alone kit, Attaching the hat flanges to the storage system, Qvwdoolqj wkh 6wdqg$orqh .lw – Dell PowerVault 211S (SCSI) User Manual
Page 34
3-2
Dell PowerVault 200S, 201S, 210S, and 211S Storage Systems Installation and Service Guide
,QVWDOOLQJ WKH 6WDQG$ORQH .LW
To install the rack storage system in a stand-alone unit, perform the following tasks
(as described in the following subsections):
1.
Attach the hat flanges to the storage system.
2.
Attach the stabilizers to the stand-alone chassis.
3.
Install the storage system in the stand-alone chassis.
4.
Complete the installation.
$WWDFKLQJ WKH +DW )ODQJHV WR WKH 6WRUDJH 6\VWHP
1.
Remove all of the installed hard-disk drives from the storage system.
2.
Carefully place the storage system on its left side.
The enclosure indicator lights should be at the top.
3.
If the nut-plate mounting screws (shown in Figure 3-1) and the sliding lock bar are
present, remove the front two screws and discard them.
If neither the screws nor the bar is present, go to step 4.
)LJXUH 5HPRYLQJ WKH 6OLGLQJ /RFN %DU RU 1XW3ODWH 0RXQWLQJ
6FUHZV
1
Nut-plate mounting screws