Dell PowerEdge R510 - Manual (Page 48)

48
About Your System
Keyboard fuse has
failed
Overcurrent detected at the
keyboard connector. See "Getting Help" on
page 199.
Local keyboard
may not work
because all user
accessible USB
ports are
disabled.
If operating
locally, power
cycle the system
and enter system
setup program to
change settings.
The USB ports are disabled
in the system BIOS. Power down and restart the
system from the power
button, and then enter the
System Setup program to
enable the USB port(s).
See "Entering the System
Setup Program" on page 62.
Manufacturing
mode detected
System is in manufacturing
mode. Reboot to take the system
out of manufacturing mode.
Maximum rank
count exceeded.
The following
DIMM has been
disabled: x
Invalid memory
configuration. The system
runs but with the specified
memory module disabled. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 115.
Memory
Initialization
Warning: Memory
size may be
reduced
Invalid memory
configuration. The system
runs but with less memory
than is physically available. Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module
Installation Guidelines" on
page 115.
Message Causes Corrective Actions
book.book Page 48 Friday, November 20, 2009 2:56 PM