Warning messages, Diagnostics messages – Dell POWEREDGE 1955 User Manual

Page 40

Advertising
background image

40

About Your System

Warning Messages

A warning message alerts you to a possible problem and prompts you to respond before the system
continues a task. For example, before you format a diskette, a message will warn you that you may lose all
data on the diskette. Warning messages usually interrupt the task and require you to respond by typing

y

(yes) or

n

(no).

NOTE:

Warning messages are generated by either the application or the operating system. For more information,

see the documentation that accompanied the operating system or application.

Diagnostics Messages

When you run system diagnostics, an error message may result. Diagnostic error messages are not
covered in this section. Record the message on a copy of the Diagnostics Checklist in "Getting Help,"
then follow the instructions in that section for obtaining technical assistance.

Unsupported CPU

combination

Mismatched processors are installed.

Processor is not supported by the
server module.

Replace a microprocessor so that both
microprocessors match. See "Processors"
on page 84.

Check for a BIOS update using the Dell
Support website at support.dell.com.

Unsupported CPU stepping

detected

Processor is not supported by the
server module.

Check for a BIOS update using the Dell
Support website at support.dell.com. If
the problem persists, install a supported
processor. See "Processors" on page 84.

Warning! No microcode

update loaded for

processor

n

Unsupported processor.

Update the BIOS firmware using the
Dell Support website at
support.dell.com.

Warning: The current

memory configuration is

not validated. Change it

to the recommended memory

configuration or press any

key to continue.

There is no memory configuration
error, but the memory configuration is
not recommended by Dell.

See "General Memory Module
Installation Guidelines" on page 78.

Write fault

Write fault on selected

drive

Faulty diskette, diskette drive, optical
drive, hard drive.

Replace the diskette. Ensure that the
custom cable is properly connected. See
"Troubleshooting USB Devices" on
page 105 or "T
roubleshooting Hard
Drives" on page 113 for the appropriate
drive(s) installed in your system.

Table 1-13.

Server Module Messages (continued)

Message

Causes

Corrective Actions

Advertising