Dell POWEREDGE 1955 - Manual (Page 73)

Installing System Options
73
4 Reconnect any cables that must be attached to the module.
See the documentation that accompanied the I/O module for information about its cable connections.
Server Modules
Your system can include up to 10 hot-pluggable server modules. Each server module can contain up to
two processors, two hard drives, six memory modules, and one daughter card.
Removing a Server Module
1 Ensure that the server module's power is off.
When a server module is powered off, its front-panel power indicator is amber. See Figure 1-3.
2 Press in the release latch on the inside of the upper handle. See Figure 3-11.
3 Pull out both the upper and the lower handles to eject the server module from the chassis.
4 Slide the server module out of the chassis.
NOTICE:
If you are permanently removing the server module, install a server module blank. Operating the system
for extended periods of time without a server module blank installed can cause the system to overheat.
Figure 3-11. Removing and Installing a Server Module
1 chassis 2 upper handle 3 server module
4 lower handle 5 release latch inside of upper
handle
2
3
4
5
1