Dell Inspiron One 2320 (Mid 2011) - Manual (Page 53)

System-Board Shield 53
12
System-Board Shield
WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
Removing the System-Board Shield
1 Follow the instructions in "Before You Begin" on page 11.
2 Remove the back cover. See "Removing the Back Cover" on page 19.
3 Remove the rear-stand assembly. See "Removing the Rear-Stand Assembly"
on page 35.
4 Remove the rear I/O cover. See "Removing the Rear I/O Cover" on page 39.
5 Remove the side I/O cover. See "Removing the Side I/O Cover" on page 41.
6 Remove the five screws that secure the system-board shield to the chassis.
book.book Page 53 Thursday, May 3, 2012 1:21 PM