Replacing the antenna-in connector – Dell Inspiron One 2320 (Mid 2011) User Manual
Page 90
90
Antenna-In Connector
Replacing the Antenna-In Connector
1 Follow the instructions in "Before You Begin" on page 11.
2 Slide the antenna-in connector into the slot on the chassis.
3 Replace the two screws that secure the antenna-in connector to the
chassis.
4 Connect the antenna-in cable to the connector on the Mini-Card.
5 Replace the system-board shield. See "Replacing the System-Board Shield"
6 Replace the rear I/O cover. See "Replacing the Rear I/O Cover" on page 40.
7 Replace the side I/O cover. See "Replacing the Side I/O Cover" on page 41.
8 Replace the rear-stand assembly. See "Replacing the Rear-Stand Assembly"
9 Replace the back cover. See "Replacing the Back Cover" on page 21.
CAUTION:
Before turning on the computer, replace all screws and ensure that no
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
1
screws (2)
2
antenna-in connector cable
1
2
book.book Page 90 Thursday, May 3, 2012 1:21 PM