Antenna module, Removing the antenna module – Dell Inspiron One 2320 (Mid 2011) User Manual
Page 93
Antenna Module
93
22
Antenna Module
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
Removing the Antenna Module
1 Follow the instructions in "Before You Begin" on page 11.
2 Remove the back cover. See "Removing the Back Cover" on page 19.
3 Remove the rear-stand assembly. See "Removing the Rear-Stand Assembly"
4 Remove the VESA mount. See "Removing the VESA Mount" on page 37.
5 Follow the instructions from step 3 to step 5 in "Removing the Optical
6 Remove the rear I/O cover. See "Removing the Rear I/O Cover" on page 39.
7 Remove the side I/O cover. See "Removing the Side I/O Cover" on page 41.
8 Remove the system-board shield. See "Removing the System-Board
9 Remove the middle frame. See "Removing the Middle Frame" on page 71.
10 Follow instructions in step 8 to step 11 in "Removing the Processor
11 Disconnect the antenna cables from the connectors on the Mini-Card.
12 Remove the four screws that secure the antenna modules to the chassis.
13 Make a note of the antenna cable routing and release the antenna cable.
book.book Page 93 Thursday, May 3, 2012 1:21 PM