Dell Inspiron XPS Gen 2 - Manual (Page 86)

86
Adding and Replacing Parts
www
.dell.com | support.dell.com
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin
working inside the computer.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other
than Dell.
NOTE:
If you are installing a hard drive from a source other than Dell, you need to install an operating
system, drivers, and utilities on the new hard drive.
To replace the hard drive:
1 Follow the procedures in "Before You Begin" on page 83.
2 Turn the computer over, and remove the hard drive screws.
NOTICE:
When the hard drive is not in the computer, store it in protective antistatic packaging. See
"Protecting Against Electrostatic Discharge" in the Product Information Guide.
3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE:
Use firm and even pressure to slide the drive into place. If you use excessive force, you may
damage the connector.
5 Slide the hard drive into the bay until it is fully seated.
6 Replace and tighten the screws.
7 If the new hard drive is not already pre-imaged, install the operating system and drivers for
your computer.
hard drive
screws (2)
G8011bk2.book Page 86 Thursday, March 31, 2005 1:50 PM