Dell Inspiron XPS Gen 2 - Manual (Page 90)

90
Adding and Replacing Parts
www
.dell.com | support.dell.com
NOTICE:
If the memory module is not installed properly, the computer may not boot properly. No error
message indicates this failure.
As the computer boots, it detects the additional memory and automatically updates the system
configuration information. If prompted, press <F1> to continue.
To confirm the amount of memory installed in the computer, click the Start button, click Help
and Support, and then click Computer Information.
Modem
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on the back of the computer).
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin
working inside the computer.
1 Follow the procedures in "Before You Begin" on page 83.
2 Turn the computer over and loosen the captive screws from the modem cover.
3 Place your finger under the cover at the indentation and lift the cover open.
G8011bk2.book Page 90 Thursday, March 31, 2005 1:50 PM