Dell Inspiron XPS Gen 2 - Manual (Page 99)

Adding and Replacing Parts
99
8 Lift the display away from the computer at a 90-degree angle. Ensure that the antenna cables,
light cable, and display cable are free from the routing channels and that the cables move
freely when you lift the display.
When you replace the display, ensure that the display cable and the light cable are securely
tucked underneath the tabs in the routing channels. Insert the antenna cables through the
hinge cover opening and then through the hole in the system board. Ensure that the antenna
cables are not twisted and that they are securely attached to the Mini PCI card.
Optical Drive
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
1 Follow the procedures in "Before You Begin" on page 83.
2 Turn the computer over.
screws (4)
display cable pull-tab
display cable connector
customizable-light cable connector
antenna cables
customizable-light
cable
G8011bk2.book Page 99 Thursday, March 31, 2005 1:50 PM