Dell POWEREDGE M1000E - Manual (Page 20)

Fabric OS v6.4.1 Release Notes v1.0 Page 20 of 62
FOS Features FOS Features FOS Features FOS Features (supported in interopmode 0) FOS v6.4 FOS v6.4 FOS v6.4 FOS v6.4
IM = Interopmode IM = Interopmode IM = Interopmode IM = Interopmode IM 2 IM 2 IM 2 IM 2 IM 3 IM 3 IM 3 IM 3
Adaptive Networking: QoS No No
Adaptive Networking: Ingress Rate Limiting No* No*
Advanced Performance Monitoring (APM) No* No*
APM: TopTalkers No* No*
Admin Domains No No
Secure Fabric OS 5 N/A N/A
Fabric Watch Yes Yes
Ports on Demand (POD) Yes Yes
NPIV Yes Yes
Timer Server function (NTP) No No
Open E_Port 6 N/A N/A
Broadcast Zoning No No
FDMI No No
Remote Switch No No
Port Mirroring Yes Yes
Extended Fabrics Yes Yes 7
Alias Server No No
Platform Service No No
FCIP (VE_Ports) Yes Yes
IPFC (IP over FC) Yes 8 Yes 8
M-EOS ALPA 0x13 configuration Yes Yes
VE to VEX Port Yes Yes
Integrated Routing 9 Yes 9 Yes
Domain Offset Support Yes Yes
239 Domain Support (available on Mi10k only) N/A Yes
Masterless F_PORT Trunking (AG connect to FOS switches only) Yes Yes
FC10-6-to-FC10-6 ISL Yes Yes
RASLOG Events on duplicate WWNs Yes Yes
Virtual Fabrics Yes Yes
Logical Fabric using LISLs (XISLs in Base Fabric) No No
Port Fencing Yes Yes
Bottleneck Detection Yes Yes
Lossless DLS No No
* indicates the feature is available but not officially tested or supported
1. Requires M-EOS 9.7 or later for redirection between devices attached to FOS switches, M-EOS 9.8 for
redirection between devices attached to M-EOS switches, M-EOS 9.9 for use in McDATA Open Fabric
Mode. Supported M-EOS platforms include M4400, M4700, M6140, and Mi10k.
2. Only allowed between FOS-based switches.
3. DPS is supported outbound from FOS-based switches. (M-EOS can provide reciprocal load balancing
using OpenTrunking).
4. SCC policies only supported in conjunction with L2 Fabric Binding support.
5. Not supported in FOS 6.0 or later.
6. Mode 3 only qualified with M-EOS switches.
7. Not on FCR.
8. Only supported locally within the FOS switch.
9. All routers (EX_Ports) must reside in a backbone fabric running in interopmode 0 only. Only edge fabrics
with devices imported to the backbone fabric or other edge fabrics may be operating in IM2 or IM3.