Configuring tcp/ip – Dell 1600n Multifunction Mono Laser Printer User Manual
Page 128
If you selected Ether Talk, press the scroll button ( or ) to change the setting to "On" (enable) or
"Off" (disable).
Press <Select> to save the selection.
6.
Configuring TCP/IP
Static Addressing: TCP/IP address is assigned manually by the system administrator.
Dynamic Addressing BOOTP/DHCP(default): TCP/IP address is assigned automatically by a DHCP or
BOOTP server on your network.
Static Addressing
To enter the TCP/IP address from your multi-function printer's operator panel, take the following steps:
Press <Menu> until you see "Network Setup" on the bottom line of the display.
1.
Press the scroll button ( or ) until "Configuration" displays on the bottom line. Press <Select>.
2.
Press the scroll button ( or ) to display "TCP/IP" and press <Select>.
3.
The first available menu item, "Manual", appears on the bottom line and press <Select>.
The first available menu item, "IP Address" displays on the bottom line.
4.
Press <Select> to access the IP Address menu.
5.
An IP address consists of 4 bytes.
Enter the numbers from the keypad and use the scroll button ( or ) to move between octets and
press <Select>.
6.
Repeat Step 5 to complete the address from the 1st byte to the 4th byte.
7.
To select other parameters, such as the Subnet Mask, Gateway or Primary DNS, press <Return>, then
use the scroll button ( or ). Press <Select>.
8.
Repeat steps 5 through 8 to configure the other TCP/IP parameters.
9.
Dynamic Addressing (BOOTP/DHCP)