Inserting the drivers and utility cd – Dell 2150cn/cdn Color Laser Printer User Manual
Page 96
94
Installing Printer Drivers on the Windows Computers
FILE LOCATION: C:\Users\fxstdpc-
admin\Desktop\0630_UG??\Mioga_SFP_UG_FM\Mioga_SFP_UG_FM\section10.fm
D E L L C O N F I D E N T I A L – P R E L I M I N A RY 9 / 1 3 / 1 0 - F O R P R O O F O N LY
The Tool Box opens.
2 Ensure that the Printer Settings Report tab is open.
3 Select TCP/IP Settings from the list at the left side of the page.
The TCP/IP Settings page appears.
If the IP address shows 0.0.0.0 (the factory default), an IP address has not
been assigned. To assign one for your printer, see "Assigning an IP Address."
Disabling Firewall Before Installing Printer Software
NOTE:
This step is necessary if you have Windows XP Service Pack 2 or 3
installed.
If your printer is connected directly to a network, and the Windows XP,
Windows Vista, Windows Server 2008, Windows Server 2008 R2, or Windows
7 firewall is enabled, you cannot view your networked printer(s) when you run
the Dell printer installation software. To prevent this situation, disable this
firewall before you install the Dell printer software. To disable or enable your
Windows XP, Windows Vista, Windows Server 2008, Windows Server 2008 R2,
or Windows 7 firewall, perform the following steps.
1 Click Start and click Help and Support.
NOTE:
For Windows Server 2008 R2 and Windows 7, if you use Online
Help, switch to Offline Help on Windows Help and Support window.
2 In the Search box, type firewall, and then press the Enter key.
In the list, click Turn Windows Firewall on or off, and then follow the
instructions on the screen.
Inserting the Drivers and Utility CD
1 Insert the Drivers and Utilities CD into your computer and click
setup_assist.exe to start Easy Setup Navigator.
NOTE:
If the CD does not launch automatically launch, follow the
procedure below.
For Windows XP, Windows Server 2008, and Windows Server 2008 R2
Click start
Run, enter
D:\setup_assist.exe
(where D is the CD drive
letter) in the Run dialog box, and then click OK.
For Windows Vista and Windows 7