Dell PowerVault 51F (8P Fibre Channel Switch) - Manual (Page 140)

A-2 Installation and Troubleshooting Guide
Figure A-1. errShow Command Example
To display error messages via Telnet:
1. From the prompt, type errShow .
2. To scroll through the error list, type CR.
3. Scroll through the error log (if no errors were encountered, the message No
Error appears).
Error Messages by Firmware Module
Table A-1 shows the error messages organized by module.
=> errShow
Error 02
--------
0x103dc470 (tSilkworm): Apr 9 10:41:06
Error SENSOR-FAILED, 3, sensor 7 (Fan 2) is below minim
Type <CR> to continue, Q<CR> to stop:
Error 01
--------
0x103dc470 (tSilkworm): Apr 9 10:40:51
Error DIAG-TIMEOUT, 1,
Port 2 receive timeout.
Type <CR> to continue, Q<CR> to stop:
value = 1 = 0x1
Table A-1. Errors
Module
Error
Severity Explanation Action
Flood INVLSR (3) An unknown Link
State Record has
been received
from a neighbor
switch. Check that all paths and
routing tables are correct
using the commands
uPathShow <domain>, or
uPathAllShow.
If the paths are not correct
reboot the neighbor switch
that sent the wrong data.
Check the paths and routes
again. If they are still incor-
rect, reboot the local switch.