Dell PowerVault 51F (8P Fibre Channel Switch) - Manual (Page 60)

3-8 Dell PowerVault 51F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
2 — Error
3 — Warning
4 — Informational
5 — Debug
See Appendix A, “Error Messages,” for more information.
These parameters can be changed via the Telnet command, agtcfgSet or via SNMP.
The sysX parameters can be configured via the SNMPv1 SET command with an
appropriate community. These parameters can be configured via a Telnet connection,
using the command
agtcfgSet .
NOTE: A change in the first two configuration parameters takes effect only after
rebooting the switch.
Name Server
The Fibre Channel Protocol (FCP) inquiry data obtained by device probing may now be
obtained from the Name Server by retrieving the port symbolic name.
Common Transport (CT) requests and responses including Name Server are recorded
in the portLog. A typical trace is shown in the following example, where port 4 logs in
to the Name Server and issues command 217. It receives an Accept (8002).
Jun 15 16:00:21.899 tReceive Rx3 4 116
22fffffc,00210413,03000000
Jun 15 16:00:21.899 tSwitch Tx3 4 116
23210413,00fffffc,02000000
Jun 15 16:00:21.899 tReceive Rx3 4 52
02fffffc,00210413,01000000
Jun 15 16:00:21.933 tNSd ctin 4 fc
00030217,00210413,00000100
Jun 15 16:00:21.933 tNSd ctout 4 fc 00008002
Jun 15 16:00:21.933 tNSd Tx3 4 0
03210413,00fffffc