Dell PowerVault 51F (8P Fibre Channel Switch) - Manual (Page 142)

A-4 Installation and Troubleshooting Guide
HLO INVHLO (1) The path selec-
tion task has
received a
HELLO message
with an invalid
parameter from a
neighbor switch. Check that all paths and
routing tables are correct. If
they are not, reboot the
neighbor switch.
Check the paths and routes
again. If they are still incor-
rect, reboot the local switch.
LSDB LSID (2) A Link State
Record received
as part of a Link
State Update has
an out of range
domain ID. Check that all paths are cor-
rect. If any path is missing
to any switch in any part of
the fabric, reboot the switch
with the missing path.
MCAST ADDBRANCH (2) A branch is being
added to a broad-
cast or multicast
tree, but the
parameters are
incorrect. If this is caused by a config-
uration command, check the
parameter values. Other-
wise, check the broadcast
tree with the bcastShow
command. If the tree is
incorrect, reboot the local
switch.
ADDPORT (3) A multicast
routing table pro-
gramming failed. Run the portLogShow
command. Contact Cus-
tomer Support.
NOPARENT (2) An error occurred
while computing
a broadcast or
multicast tree. Run the LSDbAllShow
command. Contact Cus-
tomer Support.
NOPARENTLSR (2) An error occurred
while computing
a broadcast or
multicast tree. Run the LSDbAllShow
command. Contact Cus-
tomer Support.
REMPORT (3) Removing an
entry from a mul-
ticast routing
table failed. Run the portLogShow
command. Contact Cus-
tomer Support.
SPFCOST (3) An error occurred
with computing
the multicast
path tree. Run the LSDbAllShow
command. Contact Cus-
tomer Support.
Table A-1. Errors (continued)
Module
Error
Severity Explanation Action