Dell PowerVault 51F (8P Fibre Channel Switch) - Manual (Page 144)

A-6 Installation and Troubleshooting Guide
Panic Errors
This module includes errors that cause a system panic to occur. A system panic
causes the switch to reboot. The PANIC error is stored in flash memory with a stack
trace, local stack content and local register content at the time the error occurred.
To view the trace, allow the switch to reboot and issue the traceShow command. If
the trace was caused by a PANIC error, the first line displays:
Reset reasons 0x100: Panic
PANIC errors have the highest severity (0).
NOTE: Use the traceShow command to identify PANIC errors as the errShow com-
mand is not useful in this case.
Panic errors are described in Table A-2.
MSG (3) The timer task
received an
unknown
message. Contact customer support.
Table A-1. Errors (continued)
Module
Error
Severity Explanation Action
Table A-2. Panic Errors
Error
Severity Explanation Action
FREETIMRLSD (0) A task freed an
already free timer. Issue the traceShow command.
Contact customer support.
INCONSiSTENT (0) An internal inconsis-
tency has been
detected. Issue the traceShow command.
Contact customer support.
MALLOC (0) The switch has run
out of memory. Issue the traceShow command.
Contact customer support.
MSGQCREATE (0) A message queue
could not be created. Issue the traceShow command.
Contact customer support.
MSGQDELETE (0) A message queue
could not be
destroyed. Issue the traceShow command.
Contact customer support.
SEMCREATE (0) A semaphore could
not be created. Issue the traceShow command.
Contact customer support.
SEMDELETE (0) A semaphore could
not be destroyed. Issue the traceShow command.
Contact customer support.