Dell PowerVault 51F (8P Fibre Channel Switch) - Manual (Page 143)

support.dell.com Error Messages A-5
NBFSM NGBRSTATE (2) An error occurred
in the neighbor
Finite State. Check the neighbor’s state
with the nbrStateShow
command.
If the state is not
NB_ST_FULL, force a state
change with the
portDisable command fol-
lowed by portEnable.
After a few seconds, if the
state is not NB_ST_FULL,
reboot both the local and
remote switches.
UCAST ADDPATH (1) A static path con-
figuration failed. Check command
parameters.
RELICPDB (2) The path selec-
tion task received
an E_Port SCN,
but the port was
already ISL. Run the ucastAllShow
command. Contact cus-
tomer support.
SPFCOST(3) An error occurred
with computing
the unicast path
tree. Run the LSDAllShow com-
mand. Contact customer
support.
MQ QREAD (1) A task was
unable to receive
a message. Run the command show
<queue ID> with the ID of
the queue reported in the
error. Contact customer
support.
QWRITE (1) A task was not
able to post a
message on a
queue. See “MQ-QWRITE Error”
found later in this chapter for
more information.
SYS NOMEM (1) The system’s
memory is
exhausted. Reboot the switch. Contact
customer support.
SYSCALL (2) A system call into
VxWorks failed. Reboot the switch. Contact
customer support.
TIMERS ENQFAIL (1) An error occurred
while setting a
timer. Reboot the switch. Run the
commands
actTimersShow
and
timerShow <timer ID>.
Contact customer support.
Table A-1. Errors (continued)
Module
Error
Severity Explanation Action