Dell Compellent Series 40 User Manual
Page 161
153
Viewing FC Folders and Cards
•
Description: Identification of the card
•
Status: Up or Down
•
Speed: IO speed
•
Fault Domain: If port is front-end, shows fault domain. If port is back-end, this is blank.
•
Network: Whether the card is configured Front End, Back End, or Unknown.
•
NPIV Mode: Indicates whether NPIV Mode is turned on to allow FC Virtual Ports. To
convert an FC port to Virtual Mode, NPIV must be enabled on the attached switch.
•
Initiator Count: Number of front end devices
•
Target Count: Number of disk drives
•
Both Count: Total of front-end devices and back-end disk drives
•
Map Count: Number of volumes mapped to this system
To view general information for an FC port – virtual ports
1 In a Controller folder, select an Virtual Port. The Virtual Port General Information
window appears.
Figure 121. FC IO Card General Information – Virtual Port
The window displays:
•
Physical Port Association: Preferred or Not Preferred
•
For both the Current and the Preferred Physical Port, the window displays:
•
World Wide Name
•
Fault Domain
•
Name of the Controller