Adding a remote system to iscsi ports – Dell Compellent Series 40 User Manual
Page 182
174
Storage Center 5.5 System Manager User Guide
Controllers
Adding a Remote System to iSCSI Ports
You can add a remote Storage Center system to a local system through the Storage
Management menu. From the Storage Management menu, select, System > Setup > Add
iSCSI Remote Compellent Connections menu or you can use the shortcut menu as
described below.
1 Select an iSCSI folder.
In a dual-controller system, it does not matter which of
the two folders you select; connecting the remote system to the cards in one controller
connects the remote system to all cards on both controllers.
Figure 141. iSCSI Folder Shortcut Menu
2 From the shortcut menu, select Add iSCSI Remote Compellent Connections.
•
If the local system has CHAP enabled, the configure CHAP window appears. If you
are using CHAP, refer to
Configuring Remote Connections Using CHAP on
.
•
If the local system is not using CHAP, the Add iSCSI Remote Compellent
Connections window appears, asking if NAT is configured.
Figure 142. NAT