Dell Compellent Series 40 - Manual (Page 414)

406 Storage Center 5.5 System Manager User Guide
Configuring a UPS
Introduction
This appendix describes setting up a UPS. For a dual controller, connect to the actual IP
address of a each controller. The management IP of a dual controller is used for traps.
Configuring an APC™ UPS
You can configure up to four access control entries to specify which Network Management
Systems (NMS) have access to this UPS.

To configure APC UPS
1 In a new browser window, enter the IP address of the UPS, assigned or derived from
DHCP. The UPS Network Management card appears.
Figure 318. APC UPS Network Management Card
2 Click the Administration tab.