Two Brothers Racing Honda CBR600RR - Manual

V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance part,
please consult with your local motorcycle dealer. Read all instructions first before
starting installation. Be sure to save all stock components for possible use later.
This product was designed for use with no aftermarket or O.E.M. accessories
installed. Any modifications or installation of aftermarket accessories may cause
excessive heat and could result in the damage of the vehicle. Two Brothers Racing
will not be responsible for damaged parts due to heat related issues.
Installation Instructions
1. Make sure the bike is completely cool before starting
the installation. Make sure the bike is secure on the
sidestand or ideally a rear service stand.
2. Remove passenger seat and main seat.
3. Remove bolts from rear cowling and slide cowling back.
4. Disconnect modular connector on the left side of the
bike leading to the tail light assembly.
5. Remove the tail light assembly bolts and slip the tail
light assembly back and remove.
6. Remove the side bolt and one top bolt securing the heat
shield.
7. Remove right side plastic cover from over exhaust tube
heat shield.
8. Remove bolt securing lower end of exhaust tube heat
shield (above driver’s right footpeg mount).
9. Remove right side passenger footpeg.
10. Re-install the OEM Heatshield.
11. Remove upper exhaust tube heat shield mounting bolts.
This bolt will not be used with the TBR exhaust.
2007-10 Honda
CBR600RR
V.A.L.E.™ Slip-on Exhaust System with M-2 Canister
Part # 005-1750406V / 005-1750407V / 005-1750408V
Continued on Page 2