Cisco 3.3 - Manual (Page 268)

Chapter 7 User Management
Advanced User Authentication Settings
7-22
User Guide for Cisco Secure ACS for Windows Server
78-16592-01
To assign a downloadable IP ACL to a user account, follow these steps:
Step 1 Perform Step 1 through Step 3 of Adding a Basic User Account, page 7-4 .
The User Setup Edit page opens. The username being added and edited is at the
top of the page.
Step 2 Under the Downloadable ACLs section, click the Assign IP ACL: check box.
Step 3 Select an IP ACL from the list.
Step 4 Do one of the following:
• If you are finished configuring the user account options, click Submit to
record the options.
• To continue to specify the user account options, perform other procedures in
this chapter, as applicable.
Advanced User Authentication Settings
This section presents the activities you perform to configure user-level TACACS+
and RADIUS enable parameters.
This section contains the following topics:
• TACACS+ Settings (User), page 7-23
– Configuring TACACS+ Settings for a User, page 7-24
– Configuring a Shell Command Authorization Set for a User, page 7-26
– Configuring a PIX Command Authorization Set for a User, page 7-29
– Configuring Device-Management Command Authorization for a User,
page 7-30
– Configuring the Unknown Service Setting for a User, page 7-32
• Advanced TACACS+ Settings (User), page 7-33
– Setting Enable Privilege Options for a User, page 7-33
– Setting TACACS+ Enable Password Options for a User, page 7-35
– Setting TACACS+ Outbound Password for a User, page 7-37