Setting bbsm radius parameters for a user – Cisco 3.3 User Manual

Page 298

Advertising
background image

Chapter 7 User Management

Advanced User Authentication Settings

7-52

User Guide for Cisco Secure ACS for Windows Server

78-16592-01

For more information about attributes, see

Appendix C, “RADIUS

Attributes”

, or your AAA client documentation.

Step 4

Do one of the following:

If you are finished configuring the user account options, click Submit to
record the options.

To continue to specify the user account options, perform other procedures in
this chapter, as applicable.

Setting BBSM RADIUS Parameters for a User

The BBSM RADIUS parameters appear only if all the following are true:

A AAA client is configured to use RADIUS (BBSM) in Network
Configuration.

The Per-user TACACS+/RADIUS Attributes check box is selected under
Advanced Options in the Interface Configuration section.

User-level RADIUS (BBSM) attributes you want to apply are enabled under
RADIUS (BBSM) in the Interface Configuration section.

BBSM RADIUS represents only the BBSM proprietary attributes. You must
configure both the IETF RADIUS and BBSM RADIUS attributes. Proprietary
attributes override IETF attributes.

Note

To hide or display BBSM RADIUS attributes, see

Setting Protocol Configuration

Options for Non-IETF RADIUS Attributes, page 3-17

. A VSA applied as an

authorization to a particular user persists, even when you remove or replace the
associated AAA client; however, if you have no AAA clients of this (vendor) type
configured, the VSA settings do not appear in the user configuration interface.

To configure and enable BBSM RADIUS attributes to be applied as an
authorization for the current user, follow these steps:

Step 1

Perform Step 1 through Step 3 of

Adding a Basic User Account, page 7-4

.

The User Setup Edit page opens. The username being added or edited is at the top
of the page.

Advertising