Cisco 3.3 - Manual (Page 296)

Chapter 7 User Management
Advanced User Authentication Settings
7-50
User Guide for Cisco Secure ACS for Windows Server
78-16592-01
Note To hide or display Nortel RADIUS attributes, see Setting Protocol Configuration
Options for Non-IETF RADIUS Attributes, page 3-17 . A VSA applied as an
authorization to a particular user persists, even when you remove or replace the
associated AAA client; however, if you have no AAA clients of this (vendor) type
configured, the VSA settings do not appear in the user configuration interface.
To configure and enable Nortel RADIUS attributes to be applied as an
authorization for the current user, follow these steps:
Step 1 Perform Step 1 through Step 3 of Adding a Basic User Account, page 7-4 .
The User Setup Edit page opens. The username being added or edited is at the top
of the page.
Step 2 Before configuring Nortel RADIUS attributes, be sure your IETF RADIUS
attributes are configured properly. For more information about setting IETF
RADIUS attributes, see
Setting IETF RADIUS Parameters for a User, page 7-38 .
Step 3 In the Nortel RADIUS Attributes table, to specify the attributes that should be
authorized for the user, follow these steps:
a. Select the check box next to the particular attribute.
b. Further define the authorization for that attribute in the box next to it.
c. Continue to select and define attributes, as applicable.
For more information about attributes, see Appendix C, “RADIUS
Attributes” , or your AAA client documentation.
Step 4 Do one of the following:
• If you are finished configuring the user account options, click Submit to
record the options.
• To continue to specify the user account options, perform other procedures in
this chapter, as applicable.