Configuring bbsm radius settings for a user group – Cisco 3.3 User Manual

Page 241

Advertising
background image

6-51

User Guide for Cisco Secure ACS for Windows Server

78-16592-01

Chapter 6 User Group Management

Configuration-specific User Group Settings

To configure and enable Juniper RADIUS attributes to be applied as an
authorization for each user in the current group, follow these steps:

Step 1

Confirm that your IETF RADIUS attributes are configured properly.

For more information about setting IETF RADIUS attributes, see

Configuring

IETF RADIUS Settings for a User Group, page 6-38

.

Step 2

In the navigation bar, click Group Setup.

The Group Setup Select page opens.

Step 3

From the Group list, select a group, and then click Edit Settings.

The Group Settings page displays the name of the group at its top.

Step 4

From the Jump To list at the top of the page, choose RADIUS (Juniper).

Step 5

In the Juniper RADIUS Attributes table, specify the attributes to be authorized for
the group by selecting the check box next to the attribute. Where applicable,
further define the authorization for that attribute in the field next to it. For more
information about attributes, see

Appendix C, “RADIUS Attributes”

, or the

documentation for network devices using RADIUS.

Note

The MS-CHAP-MPPE-Keys attribute value is autogenerated by
Cisco Secure ACS; there is no value to set in the HTML interface.

Step 6

To save the group settings you have just made, click Submit.

For more information, see

Saving Changes to User Group Settings, page 6-56

.

Step 7

To continue specifying other group settings, perform other procedures in this
chapter, as applicable.

Configuring BBSM RADIUS Settings for a User Group

BBSM RADIUS represents only the BBSM RADIUS VSA. You must configure
both the IETF RADIUS and BBSM RADIUS attributes.

Advertising