Sony LBT-D670AV - Manual (Page 12)

Chapter 3:
the
Radio
Listening to the Radio
Presetting Radio Stations
Playing Preset Radio
Stations
Listening to the
Radio
When you want to listen to a radio
program, you can have the tuner
automatically scan the radio frequencies
and tune in the stations with clear signals.
This feature saves you time in searching for
stations with clear signals.
However, stations with weak signals may
be skipped by automatic tuning. Manually
tune in stations with weak signals.
STEREO/
MONO
2
ENTER/
NEXT
1
1
Press TUNER/BAND repeatedly until
the band you want appears in the
display.
Each time you press this button, the
band changes as follows:
EM ◄—► AM
I
2
Press TUNING MODE repeatedly until
"AUTO" appears in the display.
t - “ i- 1 u U 1- JV'JV’
•{or /* Press TUNING +/-
the remote).
The tuner starts scanning radio
frequencies, and stops when it finds a
clear station. "TUNED" appears in the
display. "STEREO" also appears if the
FM station tuned in is broadcasting in
stereo.
4
If you don't want to listen to the
selected station, press TUNING +/- (or
I /►►! on the remote) to restart the
When the desired station is not
tuned in
Automatic tuning may skip the stations
with weak signals and continue scanning
without a stop. In this case, tune in the
station manually.
1 Press TUNING MODE repeatedly until
"MANUAL" appears in the display.
2 Press TUNING (or (◄◄ / ►►! on
the remote) repeatedly until the desired
station is tuned in.
To improve AM broadcast reception
Reorient the supplied AM loop antenna for
AM.
To change the AM tuning interval
The AM tuning interval is preset to 10 kHz
at the factory. If you need to change the
interval to 9 kHz, do as follows:
1 Turn on the power.
2 Change the band to AM.
3 Turn off the power.
4 Turn the power back on while pressing
ENTER/NEXT.
After changing the AM tuning interval,
reset the preset AM radio stations.
When an FM program is not received dearly
Press STEREO/MONO so that "MONO"
appears in the display. There will be no
stereo effect, but the reception will
improve. Press STEREO/MONO again to
restore the stereo effect.
One Touch Play feature
Press TUNER/BAND (or TUNER/BAND
on the remote) when the power is off or
when you are listening to another sound
source.
You can listen to the last received station
without pressing any other buttons.
Note
When you listen to a sound source other
than the tuner, you can select the tuner by
pressing TUNER/BAND (Automatic
Source Selection).
1 2 Chapter 3: the Radio