Sony LBT-D670AV - Manual (Page 28)

Connecting Optional
Equipment
For greater enjoyment of your stereo
system, you can connect other components
to the stereo. You can connect:
. a VCR to the VIDEO (AUDIO) IN jacks
• a turntable to the PHONO IN jacks
• headphones to the PHONES jack on the
front panel
• an LD player to the VIDEO (AUDIO) IN
jacks
To connect a VCR
1 Connect the VCR or other video
equipment to the VIDEO (AUDIO) IN
jacks.
2 Press FUNCTION repeatedly until
"VIDEO" appears in the display.
The cormected sound source comes
through the speakers.
You can also record the VCR sound.
To connect a turntable
1 Connect the turntable to the PHONO IN
jacks on the rear panel.
2 Press FUNCTION until "PHONO"
appears in the display.
The turntable sound comes through the
speakers.
You can also record the turntable sound.
Note
When you use the turntable, adjusting the
volume high may cause distortion or
howling. This is often caused by the bass
sound from the speakers which vibrate the
floor and air. That vibration could he
picked up by the needle of the turntable,
and produce the distortion or howling. To
avoid distortion or howling, do the
following:
1 Keep some distance between the
speakers and the turntable.
2 Stop using the surround effect.
3 Install the speakers or the turntable on a
firm and solid place.
4 Set DBFS to "DBFB i^W " or off.
To connect an LD player
1 Connect the LD player to the VIDEO
(AUDIO) IN jacks.
2 Press FUNCTION repeatedly until "LD"
appears in the display.
The connected sound source comes
through the speakers.
You can also record the LD player
sound.
Note
If "LD" does not appear in the display even
if you have pressed FUNCTION, press
SYSTEM POWER while pressing down
FUNCTION when the power is off.
"VIDEO" will be switched to "LD." To
return to "VIDEO", follow the same
procedures for changing to "LD."
28 chapter 7: Additional Features