Canon BJ-200e - Manual (Page 27)

8. Start your print operation.
Turning Off Envelope Mode
After printing on envelopes, follow these steps before printing on normal
paper again:
1. Set the paper selection lever (on the right side of the sheet feeder)
to the back position.
2. Set the green paper thickness lever (inside the printer) to the left
position.
3. Disable the envelope mode: make sure the printer is on-line; then
press and hold the LF/FF button and press the ON LINE button.
4. Press ON LINE again to set the printer on-line.
Use the envelope mode only when you are loading envelopes; do not use
this mode when loading regular or thick paper.
Manually Feeding Thick Paper or Transparencies
You use the manual feed feature when printing on paper that is a heavier
weight (up to 28lb or 105 g/m²) or a transparency stock.
Use transparencies that are intended for use with ink jet printers. For
best results, use Canon's BJ transparency film #Q07-0001-M1. You can
also use 3M's CG3480 transparency film.
To manually feed a single sheet, follow these steps:
CAUTION:
T Always feed transparencies manually.
T Use transparencies only in a normal operating environment. High
temperatures may damage a transparency.
T After printing on transparencies, feed at least two sheets of paper
through the printer to clean the rollers.
T Do not use Canon's CF-101 or CF-102 transparency film with this
printer; these transparencies are designed for use with our color
printers only.