Canon BJ-200e - Manual (Page 76)

DIP switch 1
Use this switch to change the horizontal print position according to the
size of your paper. If you are using letter-size paper or COM 10
envelopes, set this switch OFF; the left margin will be 0.25 inch (6.4
mm). If you are using A4-size paper or DL-size envelopes, set this
switch ON; the left margin will be 0.13 inch (3.4 mm).
DIP switch 2
If you are using a software application that assumes 66 lines will fit on
each page, set this switch to ON. The printer will reduce the line spacing
by a factor of 14/15, which is from 62 lines per page to 66 lines per page
if line spacing is set to 6 lines per inch (lpi).
DIP switch 3
If you are using letter-size paper, set this switch OFF; this sets the page
length to 11 inches. If you are using A4-size paper, set this switch ON;
this sets the page length to 12 inches.
DIP switch 4
When this switch is OFF, the printer uses the Epson Italics character set,
which includes italic characters. When this switch is ON, the printer uses
the Epson Graphics character set, which is the same as the MS-DOS
code page 437 (this character set includes symbols, lines, corners, and
European characters).
To see samples of the character sets available in Epson LQ mode, use
Canon's toll-free fax retrieval system. Call the Canon help desk and
request the fax retrieval system; then request the BJ-200e Printer
Command Summary.
DIP switches 5, 6, 7
These switches allow you to select one of eight international character
sets. These character sets provide you with the characters and symbols
used in other languages.
11 Printer control mode BJ-10 mode Epson LQ
mode
12 Automatic emulation
switching mode Disabled Enabled
NOTE: In Epson LQ mode, you use this DIP switch with one-half
reduction mode only.