Canon BJ-200e - Manual (Page 78)

To change a DIP switch setting, follow these steps:
1. Make sure the printer is turned off.
2. Open the DIP switch cover on the top of the printer. Pull the
cover toward you lifting from the notch at the top of the cover.
You may need to use a thin object, such as a coin, to release the
cover. The cover slides down into the printer.
3. Use a pointed object, such as a ballpoint pen, to change the DIP
switch settings. A DIP switch is OFF when it is up, and ON when
it down.
4. Close the DIP switch cover after making your selections.
The new DIP switch settings take effect when you turn on the printer.
If you turn off or reset the printer, or if the printer receives the Set Initial
Conditions command from a software program, the printer resets its
functions to the settings defined by the DIP switches.