Canon BJ-200e - Manual (Page 64)

1. Make sure the paper is not sticking together. Fan the stack of
paper before placing in in the sheet feeder. Always fan a stack of
paper along the edge that will feed into the printer first.
2. Check that the paper rest is extended and the paper selection lever
is in the back position for automatic loading of paper.
3. Do not stack too many sheets of paper in the sheet feeder. Try
removing a few sheets of paper from the sheet feeder.
4. If the sheet feeder contains different types of paper, load just one
type of paper.
5. Do not use curled or bent paper, which may fall into the manual
feed slot and cause the paper to misfeed.
Paper Is Loaded Skewed (Printing Is Skewed)
1. Check that the paper rest is extended and the paper selection lever
is back.
2. Make sure the stack of paper is straight in the sheet feeder.
3. Check that the right side of the stack of paper is aligned against
the right side of the sheet feeder and the left side is aligned against
the paper guide.
NOTE: The paper selection lever must be in the back position before
you stack paper in the sheet feeder.