Canon BJ-200e - Manual (Page 73)

DIP Switch Functions
DIP switch 1
Use this switch to change the horizontal print position according to the
size of your paper. If you are using letter-size paper or COM 10
envelopes, set this switch OFF; the left margin will be 0.25 inch (6.4). If
you are using A4-size paper or DL-size envelopes, set this switch ON;
the left margin will be 0.13 inch (3.4 mm).
DIP switch 2
If you are using a software application that assumes 66 lines will fit on
each page, set this switch to ON. The printer will reduce the line spacing
by a factor of 14/15, which is from 62 lines per page to 66 lines per page
if line spacing is set to 6 lines per inch (lpi).
DIP switch 3
If you are using letter-size paper, set this switch OFF; this sets the page
length to 11 inches. If you are using A4-size paper, set this switch ON;
this sets the page length to 12 inches.
DIP switch 4
When this switch is OFF, the printer uses Character Set 1. When this
DIP
switch
Function OFF ON
1 Horizontal print
position Letter size or
COM 10 envelope A4 size or
DL size envelope
2 Text scale mode Disabled Enabled
3 Page length 11 inches 12 inches
4 Character set Set 1 Set 2
5, 6, 7 Code page See following
descriptions
8 Automatic carriage
return (CR) Normal line feed (LF) LF with CR
9 Alternate Graphics
Mode (AGM) Disabled Enabled
10 Buffer size Input: 50.4 KB
Download: 0 KB Input: 9.4 KB
Download: 41
KB
11 Printer control
mode BJ-10 mode Epson LQ mode
12 Automatic
emulation
switching mode Disabled Enabled