Canon BJ-200e User Manual
Page 74
switch is ON; the printer uses Character Set 2.
DIP switches 5, 6, 7
These switches allow you to select the following code page tables.
To see the samples of the character sets available with each code page
table, use Canon's toll-free fax retrieval system. Call the Canon help desk
and request the fax retrieval system; then request the BJ-200e Printer
Command Summary.
DIP switch 8
When this switch is OFF, the printer performs a normal line feed. Set
this to ON if you want the printer to perform a carriage return after each
line feed.
DIP switch 9
Set this switch ON to enable Alternate Graphics Mode (AGM). In this
mode, the printer accepts high-resolution, 24-dot, all-points-addressable
(APA) graphics commands similar to those used with conventional 24-
pin printers.
DIP switch 10
When this switch is OFF, the printer allocates the entire buffer space
(50.4 KB) to the input buffer. When you are using downloaded fonts,
change this switch to ON; the printer will allocate 41 KB of buffer space
for downloaded fonts.
DIP switch 11
When this switch is OFF, the printer is in BJ-10 mode. When this switch
is ON, the printer is in Epson LQ mode.
DIP switch 12
Set this switch ON to enable automatic emulation switching mode. In
this mode, the printer detects whether the codes being sent are BJ-10
mode or Epson LQ mode. It then selects the printer control mode to
match the printer driver selected in the MS-DOS application.
DIP switches
Code
page
5
6
7
437
OFF
OFF
OFF
850
OFF
OFF
ON
850
OFF
ON
OFF
850
ON
OFF
ON
850
ON
ON
OFF
860
ON
ON
ON
863
OFF
ON
ON
865
ON
OFF
OFF