Canon BJ-200e - Manual (Page 32)

Select your print mode as follows:
T Use HQ mode for most of your printing needs. The printer
automatically prints in HQ mode unless you change the mode with
the
PRINT MODE button.
T Use the HS mode when you are printing draft documents. Your
document will print faster but the print density will be less than in
HQ mode. HS mode uses half the amount of ink as HQ mode.
Using the Reduction Modes
The printer supports two reduction modes for printing spreadsheets and
other wide documents on regular paper. In reduction mode, the printer
reduces the out put to two-thirds or one-half of its full size.
Two-thirds Reduction Mode
In two-thirds reduction mode, the printer automatically sets the print
dimensions as follows:
NOTE: The print mode may be overridden by your software
application.
NOTE: Normally, the default print mode is HQ. If you are in Epson
LQ mode (DIP switch 11 is ON), and you select the Draft typeface with
DIP switches 8, 9, and 10, the default print mode will be HS mode.
(You can learn about DIP switches in Chapter 8, Customizing the
Printer.)
Top margin: 0.32 inch
Left margin: 0.35 inch
Print width (max.): 7.8 inch