Attaching the lens cap cord 26-a, Pass the cord through the eyelet on the lens cap, Using the finder 26-c – Canon E 500 User Manual
Page 32: Attaching the lens cap cord
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching the Lens Cap Cord
26
-
a
1. Pass the cord through the eyelet on
the lens cap.
2. Pass the grip belt through the loop
on the cord as shown.
Removing and Attaching the Lens
Cap and Lens Hood
26
-
b
Remove the lens cap before recording and hook
it onto the grip belt using the clip on the lens cap.
Replace the lens cap when you stop recording or
turn the camera off.
B Focusing Ring
13 Filter (option)
B Lens Hood
El
Lens Cap
To remove the lens hood:
Gently rotate it anti-clockwise, as shown.
To attach the lens hood:
Gently rotate it clockwise until it clicks into place.
• When using a filter, attach the lens hood in
front of the filter so that the lens cap can be
replaced.
Using the Finder
26
-c
When using the finder, pull it out fully until it
stops.
When the finder is not pulled out, you can see
your recording from as much as an arm’s length
away.
26