Chapter 2, Operating the dvr unit, First time using the dvr unit – AVer EXR6004-Mini user manual User Manual
Page 14: Chapter 2 operating the dvr unit, 1 first time using the dvr unit
8
Chapter 2 Operating the DVR unit
2.1 First Time Using the DVR Unit
1. Connect the mouse to the USB port located at front panel of the DVR unit.
2. Using the mouse and virtual keyboard (see also
) to operate the DVR system.
3. Power on the DVR unit.
4. For security purpose, the DVR system would require you to enter User ID and Password before it can
be accessed. (If this is the first time, enter the default ID [admin] and password [admin]).
Preview UI
5. Formatting the hard disk.
a.
Click Setup and enter the password
b.
Click System → Add
c.
Select the hard disk from device list and select Format type
d.
Click Format button to start formatting
e.
When formatting is done, click OK.
6. Setup the date and time in order to have correct recording time and date.
a.
Click Setup and enter the password
b.
In Time section, click Setting button of System Time.
c.
Select the date and adjust the time, and then, click OK.
7. Connect the IP camera.
a.
Click Setup >> Camera.
b.
Select camera channel and type of camera
– IP Camera.
c.
Next, mark Enable to enable the camera.
d.
Click IP Setting.
e.
Enable Protocol, and then, select protocol, mode, video format, and channel of IP camera.
f.
Enter IP address or URL of IP camera.
g.
Enter ID and password if IP camera’s access authority is required.
h.
Click OK.
i.
To connect another IP camera, follow the above steps.